BlackVue dashcams offer Battery Protection Settings to prevent your car battery from being drained when the camera is in Parking Mode. These settings are available under Settings > Firmware settings > Recording Mode> Parking Mode Recording.
1. Voltage Cut-Off
This defines the minimum voltage threshold at which the dashcam will automatically shut off to prevent excessive battery drain.
- 12V system (most passenger cars)
Range: 11.8V to 12.5V - 24V system (trucks, buses)
Range: 22.8V to 24.0V
Tip
- Higher voltage cut-off = more conservative protection.
- If unsure, 12.0V (for 12V cars) and 24.0V (for 24V vehicles) are safe starting points.
In winter, 12.2V or higher is safer, because cold temperatures reduce battery performance. Setting the cut-off below 12.0V increases the risk that the car will not start. Power to the dashcam is restored after the engine is started again.
2. Timer Cut-Off
Sets how long the dashcam will remain in Parking Mode before automatically turning off, regardless of battery voltage.
Options typically range from 1 hour up to 48 hrs.
Helpful if you only want to monitor for a fixed period while parked.
3. Priority Setting
When both Voltage Cut-Off and Timer Cut-Off are enabled, the dashcam will shut down based on whichever condition is met first.
Note
Battery Protection Settings are only applicable to 3-wire dashcam models (ACC + BATT + GND) and only when using the Hardwiring Cable or OBD-II Power Cable.
Use BlackVue’s Ultra batteries accessories for worry-free parking protection.
Battery Protection Bypass in Low-Power Sleep
When Power Saving Parking Mode is active, the dashcam's normal Cut-off Timer is automatically bypassed and disabled:
- Reason: Because the CPU and Wi-Fi networks sleep, the total current draw drops to ≤1mA. The unit can remain in standby mode for weeks without draining the vehicle's battery.